The relief header is a system of piping connecting the outlets of all the relief valves into a common pipe or header that goes to…
Tag: Relief Valve
A pipe that releases gas to disperse into the atmosphere is called a vent. If the gas is burned at the tip, it is called…
A vent scrubber is a two-phase separator designed to remove the liquid from the relieving fluids before the gas is flared or vented. The liquid…
Each relief valve should be equipped with inlet piping no smaller than the valve inlet flange size, and inlet piping should be as short as…
Two-Phase Flow There are no precise formulas for calculating orifice area for twophase flow. The common convention is to calculate the area required for the…
Conventional Valve, Balanced-Bellows Valve, or Pilot-Operated Valve The corresponding equations for liquid flow are the following: Note that a preliminary orifice size must be determined…
The flow rate for gas through a given orifice area or the area required for a given flow rate is obtained by:
Back-pressure can affect either the set pressure or the capacity of a relief valve. The set pressure is the pressure at which the relief valve…
The flow of a compressible fluid through an orifice is limited by critical flow. Critical flow is also referred to as choked flow, sonic flow,…