Oil and Gas Separator

Skip to content
Menu
  • Home
  • Privacy Policy
  • Terms
  • Contact Us
Posted on September 13, 2009October 29, 2012 by and

Oil Sensible Heat Duty

The sensible heat duty for the oil phase is:

cal-2-18

where Q0 = oil flow rate, bpd
SG = oil specific gravity
C0 = oil specific heat, Btu/lb-°F (Figure 2-13)
T1 = initial temperature, °F
T2 = final temperature, °F

Posted in Heat Transfer TheoryTagged Heat Duty

Published by and

View all posts by and

Post navigation

Prev Deck Drainage
Next Separator Heat Exchangers

Pages

  • Contact Us
  • Privacy Policy
  • Terms

Recent Posts

  • Filtration Techniques for Preventing Clogs in Low-Flow Coriolis MFCs
  • Understanding Bernoulli’s Equation with Friction in Process Engineering
  • Head Bernoulli Equation in Process Engineering
  • Separating Oil, Water, and Gas with Weir System Separators
  • Cyclone Separator Capacity

Categories

  • Article
  • Basic Configuration
  • Basic Separation
  • Condensate Stabilization
  • Crude Oil Treating System
  • Equations
  • Flotation Units
  • Fluid Properties
  • Fractions from atmospheric and vacuum distillation
  • Gas Processing
  • Heat Exchangers
  • Heat Transfer Theory
  • Hydrates
  • Influent Water Quality
  • LTX Units and Line Heaters
  • Mechanical Design of Pressure Vessels
  • Oil and Water Separation
  • Potential Operating Problem
  • Pressure Drop in Piping
  • Pressure Relief
  • Produced Water Treating System
  • Production Process Component
  • Relief Valve Sizing
  • Separation
  • Separation
  • Shell and Tube Exchangers
  • Three Phase Separator Sizing
  • Treater Vessels Sizing
  • Two Phase Oil and Gas Separation
  • Two Phase Separator Equipment
  • Two Phase Separator Sizing
  • Two Phase Separator Theory
  • Type Of Devices
  • Water Treating Equipment
  • Water Treating Theory
© Copyright 2025 – Oil and Gas Separator
Wisteria Theme by WPFriendship ⋅ Powered by WordPress